Gunboards Forums banner

1 - 6 of 6 Posts

·
Copper Bullet member
Joined
·
390 Posts
Discussion Starter #1 (Edited)
SOLD







The upper has a handful of mags through it.
The gas block/FSB is has set screws so it can be easily swapped out.
Bolt face was polished (had a burr that was leaving funky mark on my brass)
Bolt has Model 1 7.62x39 firing pin
4 30 rd mags and 1 10 rd mag (I think its 10 and not 5 rd)
4x leapers scope.

Asking $500 +shipping
 

·
Registered
Joined
·
357 Posts
Who made the upper ?
 

·
Registered
Joined
·
357 Posts
who's parts were used ???
 

·
Copper Bullet member
Joined
·
390 Posts
Discussion Starter #5 (Edited)
The upper and upper completion kit are DPMS
The bolt and carrier are from KB Manufacturing.
The barrel is not chrome lined, and I am not sure who the manufacturer is.

Here is how it shoots with my hand loads

3 rds at 100 yards from a bench with the 4x scope


These were 3 different sight in groups done with Golden Tiger at 100 yards, from a bench, and with the 4x scope.

The number of holes in these 2 pieces of paper are the number of rounds that have been shot through this rifle.

Just noticed your location. If you are in NY this upper will not be legal on a lower with pistol grip and removable magazine, and these mags are not legal there. I will not ship them to a NY address.
 

·
Registered
Joined
·
1,576 Posts
Got here today great seller!
 
1 - 6 of 6 Posts
Top