Gunboards Forums banner
1 - 3 of 3 Posts

·
Silver Bullet Member
Joined
·
1,876 Posts
Discussion Starter · #1 ·
How to remove the 03A3 rear sight? I see the small screw on the adjusting knob,loosen it and unscrew the windage screw and then there must be a screw under it holding the sight base? Any help appreciated. AGB-1
 

·
Registered
Joined
·
1,100 Posts
Your right there is a set screw once you have the parts removed.The metal is some what staked over it so it doesnt back out. You will have to clean it up a bit before the screw will back out.The sight base most likely has a couple of dimples too that are points where they staked it so it wont move.Use a block of wood,and it should tap off.Do you really need to remove it?
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top